2.
Mount the tool on the pipe, then turn the
depth feed nut clockwise to lower the upper roll
until the tool rests snugly on the pipe . Move the
groove diameter adjustment nuts to the top of
the threaded rod so as not to interfere with the
setup groove .
POWER DRIVE SETUP
DANGER
• DO NOT connect electrical
power until instructed
otherwise.
Failure to follow this instruction
could result in death or serious
personal injury.
The RG1210 tool can be attached to a power
drive using the provided support arms, drive
shaft adapter, and leg assembly .
1.
Remove all components from the packaging,
and ensure that all necessary items are included .
Refer to the “Receiving the Tool” section .
2.
Select a location for the power drive and tool
by taking into consideration the following factors:
a.
The required power supply (refer to the
power drive manufacturer’s instructions)
b.
Adequate space to handle pipe lengths
c.
A firm and level surface for the power
drive
d.
Adequate clearance around the tool for
adjustment and maintenance
3.
Using a flat-head screwdriver, remove the
caps on the support arm ports .
4.
Screw the support arms into the ports until
hand-tight . Do not overtighten .
5.
Screw together the leg assembly pieces .
6.
Align the leg assembly with the base of the
tool head . Proper orientation will have the legs
angled towards the front of the tool body .
11
REV_A
TM-RG1210
/ Operating and Maintenance Instructions Manual
Summary of Contents for RG1210
Page 2: ......
Page 22: ...This page intentionally blank ...
