Vicon Pilot Lite V1522, Installation And Operation Manual

Page: 134 / 138

4-10
|
Chapter 4 Maintenance
XX196-00 Pilot Lite
Technical Specifications
Electrical
Input Voltage: Selectable 120/230 VAC, 50/60 Hz.
Current: 270 mA nominal.
Power Consumption: 33 W nominal.
Heat Equivalent: 1.6 btu/min (0.4 kg-cal/min) max. Note: These figures
represent the conversion of 100% of the electrical energy to heat. Actual
percentage of the heat generated will be less and will vary from product to
product. These figures are provided as an aid in determining the extent of
cooling required for an installation.
Alarm Inputs: All inputs are NC or active high (CMOS/TTL compatible). 32
inputs from receivers; 32 direct alarm inputs.
Alarm Output: Normally open (NO) relay closure provides operation of
remote units such as VCRs under alarm conditions. Relay rated at 1 A, 30 V.
Fuse: 0.75 A, 5 X 20MM 250V SLO-BLO.
Video
Video Input Level: 1.0 V p-p nominal.
Input/Output Impedance: Terminated: 75 ohms.
Looping: High impedance (6.8 kohm).
Input to Input Isolation: Typical -52 dB at 4.2 MHz.
Video Gain: Unity, ±0.3 dB.
Video Frequency Flatness: 100 kHz to 10 MHz ±0.9 dB.
Total Bandwidth: 1 Hz to 20 MHz, @ -3 dB.
Tilt: Less than 1%.
Field/Line Short-Time Distortion: Less than 1%.
Chrominance to Luminance Delay: Less than 50 nsec.
Crosstalk Isolation: Typically -50 dB at 4.2 MHz between two adjacent input
channels routed to two adjacent output channels.
Hum and Noise: 70 dB below 1 V p-p up to 5 MHz.
Signal-to-Noise Ratio: Greater than 61 dBrms typical unweighted,15 kHz to
5 MHz.
Connectors: Video Inputs: 32 BNC connectors; Video Outputs: 8 BNC
connectors; Alarm Inputs: 32 on two terminal blocks; Looping Video Outputs:
4 D-Shell connectors; Alarm Relay Outputs: 3 on terminal block; Keypad
Inputs: 6 on terminal block; Receiver Inputs: 6 on terminal block;