Vicon NOVA Powerplus VP3466, Programming Manual

Page: 15 / 101

Also connect a coaxial cable to the BNC connector labeled “STATUS DISPLAY” on the decoder panel and to
the “IN” BNC connector on a monitor. This monitor will be the programming monitor and will be used to make
the programming choices required to build a customized configuration file for your system. Refer to Figure 3
for the location of the programming monitor BNC. Refer to Matrix
Super-High-Density Video
Switching System X824 for cable recommendations and further installation instructions.
Note: To edit the screen layout, as discussed on page 54, you must connect a monitor and camera to the
system. You will not be able to define the layout using the programming monitor.
Entering and Exiting the Programming Screens
After connecting the basic components discussed in the previous section, apply power to the monitor and
Matrix 66 card cage. Refer to
Matrix 66 Super-High-Density Video Switching System Installation
Manual X824 for these procedures if necessary.
Referring to Figure 3 for locations, turn the power switch located on the Matrix 66 front panel to the ON
position. Place the keyboard switch (also located on the front panel) in the ON position.
If a user ID (and passcode, for administrators) was previously entered, you must enter them before accessing
the programming screens. Managers must enter a user ID; administrators must also enter a passcode. An
example user ID is shown in the screen below.
Matrix-66
System Editor
Please
If you mistype the ID, the following screen will display and you must press Enter to access the
screen again.
Matrix-66
System Editor
- - - - - - - - -
E r r o r
Invalid User ID
PRESS ENTR TO
CONTINUE
4 Preliminary Operations
X897 Rev 1196 Nova Powerplus