Vicon CE102D, Installation Manual

Page: 54 / 71

54
• NAT traversal Settings
- Enable: Click the Enable button to enable NAT traversal; pressing the button toggles
between enable and disable. When enabled, the network camera attempts to configure port
mapping in a NAT router on your network, using UPnP. Note that UPnP must be enabled in
the network camera (see System>Network>UPnP).
Enter a NAT router and enter the external port number for the router in the field provided.
If you enter o in those fields, the network camera automatically searches for NAT
routers on your network.
Notes:
- If you attempt to manually enter a port that is already in use, an alert message will be
displayed.
- When the port is selected automatically it is displayed in this field. To change this enter a
new port number and click Save.
When the settings are complete, click Save, or click Reset to revert to previously saved settings.

Zeroconfig
Zeroconfig allows the network camera to create and assign IP address for network cameras and
connect to a network automatically.
Zero configuration networking (zeroconf), is a set of techniques that automatically creates a usable
Internet Protocol (IP) network without manual operator intervention or special configuration servers.