3.1.2
Procedure for installing the separate type balance
To use the display and the balance separately from each other
c
Lift the pan, and slide it backward.
d
Slightly open both sides of the cable cover, and mount it vertically in the cable housing.
e
Mount the base cover in the front of the cable housing so that it is hooked on the cable cover.
f
Put back the pan.
g
In order to level the balance, turn the adjusters so that the air bubble is centered in the viewer.
* Numbers in the figure correspond to
the above steps to install the balance.
Position of the air
bubble in the level
Adjuster
Cable housing
e
Base cover
d
Cable cover
To integrate the display with the balance
c
Lift the pan, and slide it backward.
d
Loosen the two knobs in the connecting fitting, and mount it vertically in the cable housing.
Check that the supporting boards are hooked on the bottom of the cable housing.
e
Fasten the two knobs in the connecting fitting.
f
Fold the cable and put it in the cable housing with 15 cm of the cable left unfolded in the
display end.
g
Slightly open both sides of the cable cover, and mount it vertically in the cable housing.
h
Insert the display in the connecting fitting at an angle.
i
Put back the pan.
j
Mount the base cover vertically.
k
In order to level the balance, turn the adjusters so that the air bubble is centered in the viewer.
g
Cable cover
e
Supporting board
Knob
Pan
Supporting board
d
(Connecting
fitting)
Adjuster
Cable housing
Knob
h
Display
j
Base cover
Cable housing
Cross-section View of Connecting Fitting Installation
10
