Chapter 1
Using Xgig Maestro
Network Connections
Xgig Maestro Introduction Guide
Page 10
Version 8.1
November 2015
Refer to Figure 6 to see that once the switch is on (1) and the USB connection has been
established with the chassis, the connected device icon in the Sync Group(s) pane of the
Select Ports for Domain Creation window changes to reflect that it is connected with the
USB. Note the icon now displays the USB symbol (2).
Also, previously, the label for the icon displayed the IP address, however, it now displays
a number starting with “127.127.” to show that it is a USB identifier (2). This number is also
shown in the address bar and in the pane with the USB switch (3).
Figure 6
Select Ports for Domain Creation Window with USB Connected
Note that if the USB cable is disconnected or the client computer is shutdown, the chassis
will go back into Ethernet mode. The chassis will go back into Ethernet mode if an Ethernet
cable is plugged into the chassis Ethernet port.
Because the Xgig Web Utility is not supported over USB, you need to use the Xgig remote
administrator. Refer to your chassis hardware guide.
