Seeker D Lite User’s Guide
Document Num., Rev. 4
May 2018
Page 31
When first entering the Preset Frequencies display or after selecting a new preset
frequency, the following will occur:
• The numeric display will show the first three digits of the
primary frequency (digits before decimal) on the top line as
shown in the image to the right. The last four digits of the
primary frequency (digits after decimal) will show on the
bottom line as shown in the image to the right.
• After a few seconds the numeric display will change to
show the tag for the primary frequency.
• When the numerical display has cycled through the primary frequency information,
the display will show the same information for the secondary frequency (if a
secondary frequency has been selected).
• When the numerical display has cycled through the information for both the primary
and secondary frequency (if selected), the display will resume RF signal level
measurement of the selected preset frequencies.
Tag Selection
Preset Frequency
In this example, the frequency preset 1 is 138.000 MHz, Tag 2.
If the meter is set to toggle two frequencies, the second
frequency preset and tag will follow the above example.
After a few seconds in the Preset Frequencies display without
any action by the user, the display will revert to the Signal
Level display.
Summary of Contents for Seeker D Lite
Page 1: ...Seeker D Lite In Home Leakage Detector User s Guide ...
Page 8: ...Seeker D Lite User s Guide Document Num Rev 4 May 2018 Page 8 ...
Page 12: ...Seeker D Lite User s Guide Document Num Rev 4 May 2018 Page 12 ...
Page 41: ...Seeker D Lite User s Guide Document Num Rev 4 May 2018 Page 41 ...
