Viavi OneAdvisor ONA-800, Getting Started Manual

Page: 28 / 75

Chapter 1
Getting started
Attaching components
ONA-800 Getting Started Guide
April 2022 22142812, R011 Page 9
Table 6 lists the expansion modules you can attach to the ONA-800 base.
The following procedure describes how to attach expansion modules to the ONA-800.
To attach expansion modules
1 Power down the ONA-800 and disconnect from AC power.
2 Place the unit so that you have access to the back and remove the termination
cover by removing the screws that hold it in place.
3 Locate the hinges on the module and insert them into the base at a 45 to 60
degree angle
4 Pivot the module down towards the connector, as shown in Figure 10 .
Figure 10 Pivot module down
5 Seat the module into the connector with slight pressure.
6 Tighten the screws on the module.
The following procedure describes how to remove CAA/OTDR modules.
To remove expansion modules
1 Power down the ONA-800 and disconnect from AC power.
Table 6 Expansion modules
Module Description
CAA Provides cable and antenna analysis
OTDR and MPO Switch Optical Time-domain Reflectometer and Multi-
Fiber Switch
OSA/OCV/OCC Optical Spectrum Analyzer/Optical Channel
Verifier/Optical Channel Checker
TEM Timing Expansion Module
PEM (ONA-800A-MF2 only) Power Extension Module