Viadrus CLAUDIUS K 2 Series, Manual For Operation And Installation

Page: 8 / 32

8
Fig. № . 3 Location mix strainer in the gas pipeline of the burner K 2 L5X
5 Storage heater VIADRUS OV - H 100
Water heater VIADRUS OV – H 100 is a pressure device adapted to operate at a maximum water pressure of 0.6
MPa (6 bar). Hot service water heater is a device designed for heating and storing hot water.
The main part of the heater is a vessel made of steel sheet coated with a layer of enamel. The heater is equipped
with a heating coil with large heat exchange surface, which ensures fast heating of large quantities of water. All
connections are located in the upper part of the heater and are terminated with an external thread. The heater also
offers the possibility of connecting a circulation pump for circulating hot water, and s temperature sensor. There is
an outlet at the bottom part of the heater through which the vessel can be drained. The heater is equipped with an
additional anticorrosive device in the form of a magnesium anode whose function is based on the utilization of the
electrochemical potential difference between the anode and the tank. The magnesium anode is placed in the upper
part in the plug 2”. Thermal insulation of the heater is made of polyurethane foam free from freon, which minimizes
heat loss. An electric heater can be installed in the heater.
Tab.
№ . 3 Technical parameters
Technical parameters VIADRUS OV – H 100
Volume l 100
Maximum allowable temperature °C 100
Maximum allowable pressure bar 6
Heat exchanger surface m
2
1.2
Heat exchanger volume l 5.6
Consumption of heating water from central heating m
3
/h 2.5
Constant efficiency (70/10/45
o
C) l/h 700
Output kW 29
Dimensions
A
mm 140
B mm 60
C mm 40
D mm 100
E mm 120
Device height L 990
Tank dimensions (without insulation) Ø 400
Tank dimensions (with insulation) mm 455x455
Insulation of soft polyurethane foam mm 30
gas
inlet
gas inlet
1. Complete burner
2. Extension tube
3. Gasket Ø 83
4. mix strainer
5. Screw M5
6. Washer 5.3
7.
Nut M5