Table of Contents
12/2/20
FM MANUAL.DOCX
Table of Contents
Copyright 2020, Vestil Manufacturing Corp.
Page 8 of 20
STEP 2 (docks with a steel edge 6” or greater). Measure the height of the dock, from the edge of the dock
to the driveway surface below the dock edge.
Height of dock edge is 50”±1”*,
…
…
Proceed to Step 4
Height of dock edge is less than 50”, but no less than 46” Proceed to Step 3
Height of dock edge is less than 46” …
…
…
Not recommended
* Assumes an optimal dock height of 50”
STEP 3. For docks lower than 50” tall, install a 2” or 4” tall steel approach ramp for your dock leveler (not
included with product). Select the approach ramp that sets the dock height to 50”±1”. The dock leveler provides
a smooth transition from the dock floor to the top of the leveler. Follow the manufacturer’s instructions for
installation. Contact your Vestil distributor to select the approach ramp that best fits your application.
STEP 4. Remove all material and protrusions from the dock face.
STEP 5. Center the leveler in the doorway of the dock, with the top edge of the mounting plate even with the
edge of the dock or the approach ramp (if installed). Tack weld the mounting plate at each end.
STEP 6. Weld the mounting plate to the dock edge. Have a qualified welder apply a continuous weld
completely around the top and both sides of the mounting plate.
