VESTEL 40UA9300, Operating Instructions Manual

Page: 154 / 176

English - 96 -
Wireless Connectivity
To Connect to a Wireless Network
The TV cannot connect to the networks with
a hidden SSID. To make your modem’s SSID
visible, you should change your SSID settings
via the modem’s software.
To Connect to a wireless LAN, you should
perform the following steps:
1.
Ensure that Nero Media Home software
is installed to your PC (for Audio Video
Sharing function).
2. To configure your wireless settings please
refer to the Network Settings section in
the System>Options Menu .
Broadband ISP
connection
A Wireless-N router (IEEE 802.11a/b/g/n)
with simultaneous 2.4 and 5 GHz bands is
designed to increase bandwidth. These are
optimized for smoother and faster HD video
streaming, file transfers and wireless gaming.
• Use a LAN connection for quicker file sharing
between other devices like computers.
• The frequency and channel differ depending
on the area.
• The transmission speed differs depending
on the distance and number of obstructions
between the transmission products, the
configuration of these products, the radio
wave conditions, the line traffic and the
products that you use. The transmission
may also be cut off or may get disconnected
depending on the radio wave conditions,
DECT phones or any other WiFi 11b
appliances. The standard values of the
transmission speed are the theoretical
maximum values for the wireless standards.
They are not the actual speeds of data
transmission.
• The location where the transmission is most
effective differs depending on the usage
environment.
• The Wireless feature of the TV supports
802.11 a,b,g & n type modems. It is highly
recommended that you should use the IEEE
802.11n communication protocol in order to
avoid any possible problems while watching
videos.
• You must change your modem’s SSID when
there are any other modems around with the
same SSID. You can encounter connection
problems otherwise. Use a wired connection
if you experience problems with a wireless
connection.
Configuring Wireless Device Settings
Open the Network Settings menu and select
Network Type as Wireless Device to start
connection process.
The TV will scan the wireless networks
automatically. A list of available networks
will be displayed. Please select your desired
network from the list.
Note: If the modem supports N mode, you
should set N mode settings.
If the selected network is protected with a
password, please enter the correct key by
using the virtual keyboard. You can use this
keyboard via the directional buttons and the
OK button on the remote control.
Wait until the IP address is shown on the
screen.