VESTEL 40UA9300, Operating Instructions Manual

Page: 131 / 176

English - 73 -
Switching On/Off
To Switch the TV On
Connect the power cord to a power source
such as a wall socket (220-240V AC, 50 Hz).
To switch on the TV from standby mode either:
• Press the Standby button, Pro/-
or a numeric button on the remote control.
• Press the Standby button or Programme
+/- on the TV.
The TV will then switch on.
To Switch the TV Off
Press the Standby button on the remote
control or press the Standby button on the
TV, then the TV switches into standby mode.
To power down the TV completely, unplug
the power cord from the mains socket.
Note:
When the TV is switched into standby
mode, the standby LED can blink to indicate
that features such as Standby Search, Over
Air Download or Timer is active. The LED
can also blink when you switch on the TV
from standby mode.
First Time Installation
When turned on for the first time, the langu-
age selection screen is displayed. Select the
desired language and press OK .
On the next screen, set your preferences
using the directional buttons.
Note: Depending on the Country selection
you may be asked to set and confirm a PIN at
this point. The selected PIN cannot be 0000.
You have to enter it if you are asked to enter a
PIN for any menu operation later.
About Selecting Broadcast Type
Aerial:
If Aerial broadcast search option is
turned on, the TV will search for digital ter-
restrial broadcasts after other initial settings
are completed.
Cable: If Cable broadcast search option
is turned on, the TV will search for digital
cable broadcasts after other initial settings
are completed. According to your other
preferences a confirmation message may be
displayed before starting to search. Select
YES and press OK to proceed. To cancel
operation, select NO and press OK . You
can select Network or set values such as
Frequency , Network ID and Search Step .
When finished, press OK button.
Note: Searching duration will change
depending on the selected Search Step .
Satellite: If Satellite broadcast search option
is turned on, the TV will search for digital
satellite broadcasts after other initial settings
are completed. Before satellite search is
performed some settings should be made.
Antenna Type menu will be displayed first.
You can select Antenna Type as Direct ,
Single Satellite Cable or DiSEqC switch
by using “ ” or “ ” buttons.
• Direct: If you have a single receiver and a
direct satellite dish, select this antenna type.
Press OK to continue. Select an available
satellite on the next screen and press OK
to scan for services.
• Single Satellite Cable: If you have multiple
receivers and a single satellite cable system,
select this antenna type. Press OK to
continue. Configure settings by following
instructions on the next screen. Press OK
to scan for services.
• DiSEqC switch: If you have multiple
satellite dishes and a DiSEqC switch ,
select this antenna type. Press OK to
continue. You can set four DiSEqC options
(if available) on the next screen. Press OK
button to scan the first satellite in the list.