11
■
Static charge voltage Measurement
Standard Static charge voltage measurement mode
1) Face this device toward a charge-free space, and press the power button for 1 to 2.5 seconds.
When the power turns on and “1” appears on the LCD display, release the button. A single “beep”
sounds to indicate that the normal measurement mode has been entered.
2) The bar graph, scale, display range, polarity, measurement value, unit (kV) and battery level
appear on the LCD screen. At the same time, the red LED for the cross mark on the front of the
product turns on, and the measurement state is activated.
Always check the battery level at this time. Refer to “Battery level display” for details on the
battery level.
3) When the power button is pressed again in the power on state, a single “beep” sounds, the
power turns off, and all displays turn off.
4) This product has an “auto power off function”. When enabled, the power turns off automatically
about five minutes after the power is turned on. Four “beeps” sound to indicate that the power
has turned off.
Standard Static charge voltage measurement mode
REMEMBER
Eye-02 can be activated by pressing POWER button just once lightly. There
is no need to press it repeatedly. Frequent unnecessary on/off operation or
pressing by a nail may affect the life of switches and the cover sheet.
Always remove the Ion Balance plate when measuring the Static charge
voltage.
* Continuous measurement for longer than five minutes is not possible when the
“
auto power off
function” is enabled. To measure continuously for more than five minutes, enable the following
“Continuous mode for static charge voltage measurement”.
