11
2015/3/9V1.0+V1.0
3.3. Assembly Steps
STEP 1
Release cross screw on frame(c) for motor upper cover fixing and take off upper motor
cover, fix the truss hex screw of upright tube into gourd hole as figure 1-1 and push it
forward. Then pull the control wire & other wires out with guide thread attached in upright
tube and fix the upright tube L,R(D,E) with screw(a), but do not tighten. Tighten outer
handrail cover L&R(H,I) on upright tube L,R with screw(e), at last tighten inner handrail
cover L,R(F,G) with screw(c,d).
STEP 2
Make control wire& other wires through the hole of stuff holder set(B), make sure the wires
is not pressed and fix the truss hex screw of stuff holder set(B) into gourd hole of upright
tube as figure 2-1, push it forward. After finished, tighten stuff holder(B) with screw(b) and
tighten the screw(a) that fixing the upright tube L,R. At last, cover the upper motor cover
back to frame(C) and tighten with cross screw.
Philips Screw
Philips Screw
Philips Screw
Philips Screw
Philips Screw
Philips Screw
