17
RFSDV34 Freestanding Direct Vent Gas Stove
10003550
Only glass approved by Vermont Castings Group may
be used for replacement. The use of substitute glass
will void all product warranties.
Take care to avoid breaking the glass.
Under no circumstances is this stove to be
operated without the front glass or with a
broken glass. Replacement of the glass (with
gasket) as supplied by the manufacturer
should be done by a licensed qualified service
person.
1. Turn the gas supply OFF (Refer to Lighting
Instructions).
. If the unit has been operating allow time for the
components to cool.
3. Open the two side doors.
4. Open the clamps on the two sides. (Fig. 6)
5. Pull the frame forward.
6. To reinstall window frame assembly, follow the above
procedure in reverse.
Clean the glass after the first two weeks of
operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam glass.
Operating Instructions
Glass Information
Window Frame Assembly Removal
Glass Cleaning
Release Clamps
( per side)
FP1517
Fig. 26
Window frame removal.
It is necessary to periodically clean the glass. During start-
up condensation, which is normal, forms on the inside of
the glass. This condensation causes lint, dust and other
airborne particles to cling to the glass surface.
Also initial paint curing may deposit a slight film on the
glass. It is therefore recommended that the glass be
cleaned two or three times with a non-ammonia based
household cleaner and warm water (We recommend
gas stove glass cleaner) within the first few weeks of
operation.
After the initial cleaning process the glass should be cleaned
two or three times during each operating season depending
on the environment in the house.
Log Identification Chart
Logs
RFSDV24
RFSDV34
Log Ember Bed
--
KR7
Log - Front Left
KR13
KR8
Log - Front Right
KR14
KR9
Log - Rear
--
KR10
Log - Top Left
--
KR11
Log - Top Right
--
KR1
Log - Rear Left
KR15
--
Log - Rear Right
KR16
--
