EUROLIFT
BH
OWNER’S MANUAL
Belt Hoist
Page 4
VERLINDE S.A. reserves the right to alter or amend the above information without notice KHHOMSBHGB2006/08
1
CONSTRUCTION AND OPERATING PRINCIPLE
1.1
Construction :
-
Frame
: Steel and SG cast iron
-
Brake motor
: IP 54 construction, 1 or 2 speed lifting type, built-in electromagnetic
brake
-
Reduction gear :
under sealed casing, greased for life, treated and ground helical
teeth
-
Drum
: composed of two flanges and a steel hub, designed so that the belt winds on
spirally
-
Belt
: the belt was specially designed for our company. it is tested and delivered with a
certificate of conformity, it has a safety factor exceeding 7, and it resistant to acids,
bases, mineral salts, solvents and oil products. It maintains their characteristics at the
following temperatures:
•
Po belt : between - 20° and + 80°
•
Dy belt : between - 30° and + 120°
-
Electrical box
: IP 55 protection, attached to hoist, and contains the following in the
standard version
•
Safety
transformer
•
Protection by transformer fuses
•
Lifting reversing switch
•
Lifting temperature relay
•
Top and bottom limit switch
•
Load limiter relay
•
Connection terminal block
-
Button box
: Complies with rules in force, cable length depending on the standard
lifting height.
Double push button for two lifting and translation speeds.
Emergency stop button allowing the user to isolate the hoist from the mains electricity
supply.
Optional : Additional buttons to control other movements.
-
Load limiter
: This electromechanical device does not change the dimensions of the
hoist. It enable a safety adjustment on site if there is overload.
- Steel construction
4-wheel crab,
electric drive, 2-speed brake motor.
- Adjustable sides to allow installation of monorail on different support beam widths.
1.2
Operation
Refer to the diagram :
