Verint NEXTIVA S2800E series, User Manual

Page: 39 / 71

Nextiva S2800e Series User Guide
Verint Video Intelligence Solutions 31
11. In the Reconfigure unit? confirmation window, click Yes. The New Network
Configuration window appears.
12. If you have a DHCP (Dynamic Host Configuration Protocol) server on your network,
check Use DHCP. Otherwise, enter the IP address, subnet mask, and gateway of the
device, as provided by your network administrator. For more information about DHCP,
see page 48.
13. Click OK. The device reboots with its new network configuration.
The S2800e initial configuration is now complete. You perform further configuration
with the Nextiva Control Center software.
Integrating the S2800e with Nextiva
Integrating the S2800e with Nextiva enables the camera functionality, including PTZ
control, camera presets, and patterns, to be controlled from Nextiva Review or a keyboard
connected to the Nextiva system.
Once the camera is added to Nextiva, you need to perform such operations on the camera
as configuring video input settings, assigning a recording profile, and assigning user rights.
Then you define the S2800e in IntelliStream (to create camera tours) and create IntelliFlow
scenarios.
The major integration steps are:
1. Discover the new camera with the System Setup Wizard in Nextiva Control Center.
2. Configure the PTZ settings in Nextiva Control Center. Select System Components >
Devices, then select the S2800e, then select the PTZ tab:
†
Check Enable the Camera PTZ Control.
†
Select the Vicon Surveyor 2000 protocol.
†
Enter 1 as the PTZ address.
†
Select the S2800e RS-232/RS-422 serial port.
For more information about camera integration with Nextiva version 5.1, refer to the
TN_5.1_093 Integrating Third-Party PTZ Cameras technical note. This document is located
on the extranet, under Community Links > Technical Notes - HotFixes - Rollups > Nextiva
Enterprise > Nextiva 5.1.
Nextiva S2800e Series User Guide.book Page 31 Wednesday, March 11, 2009 3:20 PM