Verilink WANsuite 5165, Reference Manual

Page: 168 / 235

4-44 W A N s u i t e 5 1 6 5
some cases change, parameters including Index, Interface, Type, and Pair. A
Delete Service prompt is also included on this screen.
DLCI Details Screen
The DLCI Details screen (Figure 4.37) lets you access the configuration
parameters described in the following paragraphs. To bring up this screen,
select any DLCI from the <DLCI> column on the Endpoint Table screen.
Figure 4.37 DLCI Details Screen
The unit uses the first three configuration parameters (Protocol Encapsulation,
Proprietary Traffic Type, and Proprietary Offset) to gather statistics. For in-
band management, “RFC 1490” must be the encapsulation method.
Protocol Encapsulation This is the type of encapsulation used by the FRAD/router connected to the
unit.
Values: RFC 1490, Proprietary
Default: RFC 1490
Proprietary Traffic
Type
When Protocol Encapsulation is set for “Proprietary,” the Proprietary Traffic
Type parameter defines which protocol is encapsulated.
Values: IP, IPX, Ethertype, None
Default: None
Proprietary Offset When Protocol Encapsulation is set for “Proprietary,” the Proprietary Offset
parameter defines the number of octets after the frame relay header where the
proprietary traffic type starts.
Values: 0–64
Default: 0
CIR (bps) If a Committed Information Rate is configured here, its value will be used
instead of the default CIR of the frame relay service.
Values: 0–1536000
Default: 0