Verilink WANsuite 5165, Reference Manual

Page: 153 / 235

V T 1 0 0 I n t e r f a c e 4-29
Rx Threshold Number of bits per second sent during a 15-minute interval after which an Rx
alarm will be triggered. Default of 0 disables this alarm.
Values: 0–4294967295
Default: 0
Rx Alarm Status of this alarm (OK, Alarmed).
Default CIR (bps) This is the Committed Information Rate (in bits per second) provided by your
frame relay service provider. The unit will apply this value to each DLCI
learned from the network side to gather statistics and to perform CIR
enforcement, if required. If a DLCI is configured with a CIR different from
the default, the DLCI configuration will be used instead.
Values: 0–1536000 bps
Default: 0
Default Be Rate (bps) This is the Excess Burst Rate (in bits per second) provided by your frame
relay service provider. The unit will apply this value to each DLCI learned
from the network side to gather statistics and to perform CIR enforcement, if
required. If a DLCI is configured with an Excess Burst different from the
default, the DLCI configuration will be used instead.
Values: 0–1536000 bps
Default: 0
Enforce CIR and Be If this parameter is set to “Yes,” the unit will enforce Committed Information
Rate and Excess Burst according to the Link Injection Parameter.
Values: No, Yes
Default: No
NOTICE:
The Auto Diagnostic parameter must be set to “Yes” to enforce CIR and
Be.
Management DLCI If this parameter is set to “0,” the unit will look for management traffic on
any DLCI. If set to a number associated with a specific DLCI, the unit will
look for management traffic on that DLCI only.
Management Auto IP
DLCI
If this parameter is set to “Yes,” the unit will monitor the specified
management DLCI for five pings over 5 seconds, after which the unit uses the
destination address as its management IP address.
FrameStart Auto
Diagnostic
When this parameter is set to “Yes,” the unit will always source LMI on both
sides of the frame relay connection. The unit will dynamically learn the type
of link management used on each side of the connection (Network and
Serial).
When set to “No,” the unit will monitor LMI between the Serial and the
Network port. If one side of the connection goes down, it will source LMI
until the connection goes back up, and will automatically go back to Monitor
mode once both sides are up. In Monitor mode, the unit will switch all frames