Place the spool base, thread and spool cap onto the spool pin.
If the thread spool Is smaller In size, the spool pin can remain In a horizontal position. Note:
If the thread spool has a slit on the end of it, put that end toward the right so that the
thread doesn't get caught on it while sewing.
If the thread spool is larger in size, and therefore does not feed properly when it is placed
onto the spool pin horizontally, move the spool pin to the vertical position. If the vertical
position is used, loosen the spool cap slightly or completely remove it, so that it doesn't
prevent the spool from turning while sewing.
Thread the machine with your left hand while firmly gripping the thread with your right
hand in the order shown:
1.
Guide the thread through the
thread guide at the top of the
machine.
2.
Pull the thread into the tension
discs by pulling the thread
down into the channel, as
shown.
3.
Do a U-turn around the inside of
the tab.
4.
Pass the thread through the
thread take-up lever from right
to left.
5.
Place the thread into the
thread guide.
6.
Pass the thread through the eye
of the needle from front to
back.
or
