remove the fabric.
6.
Needle Plate
is located under the presser foot area, around the feed dogs. It
provides a flat surface for the fabric while sewing.
7.
Removable Extension Bed
provides a larger surface around the arm of the
machine to support fabric while sewing. This can be removed to access the free
arm, making it possible to sew smaller, harder-to-reach areas such as pant or
sleeve hems. There is a storage compartment for the machine's accessories,
keeping accessories within hands reach.
8.
Bobbin Winding Stopper
is used in the process of winding the bobbin.
9.
Power On/Off & Speed Control Switch
is used to turn the machine on and off.
There is an “L” setting for lower speed, and an “H” setting for higher speed.
10.
Pattern Selector Dial
is used to set the machine to the stitch you want to sew. It is
numbered from
1
through
12
, and the numbers correspond to the display near
the top of the machine. Just turn the dial to the stitch you want and sew.
11.
Presser Foot Release Lever
is located at the back of the presser foot holder. Use
this lever to remove the presser foot from the presser foot holder.
12.
Needle
is placed into the needle bar and is required in order for the machine to
sew.
13.
Needle Clamp & Screw
work together to hold the needle in place for sewing.
14.
Presser Bar
holds the presser foot and presser foot holder. It is raised and
lowered using the presser foot lifter
15.
Presser Foot Holder
is attached to the presser bar. It holds the presser foot in
place for sewing.
16.
Presser Foot Screw
is located to the left of the presser foot holder. The screw is
used to secure the presser foot holder in position on the presser bar
17.
Feed Dogs
move the fabric under the presser foot.
18.
Bobbin Cover Plate
sits over the bobbin and bobbin case. It is transparent,
making it easier to monitor the thread supply.
19.
Bobbin Cover Release Button
is located to the right of the bobbin cover plate.
Press it to the right to release the cover when replacing the bobbin.
20.
Spool Pin
holds the thread spool. The spool pin holder fits onto the spool pin to
allow thread to unwind without tug or drag. The spool pin can be used in either
of two ways (horizontally or vertically), depending on the size of the thread
spool being used.
21.
Bobbin Winder
is used for smoothly and evenly winding thread onto the bobbin.
22.
Carry Handle
is built-in, making it easy and convenient for transporting the
machine.
23.
Hand Wheel
controls the movement of the take-up lever and the needle.
Always turn the hand wheel toward you.
24.
Foot Controller Input
is located at the back of the machine. The foot controller
cord must be plugged into this input before starting to sew.
25.
Power Cord Socket
at the back of the machine is where the power cord is
inserted in order to provide power to the machine.
