THREAD GUIDE
Put the end of the thread through the hole in the bobbin, as shown. Place the bobbin
onto the bobbin winder as far as it will go.
Holding onto the end (aka ‘Tail’) of the thread, push the bobbin winder firmly to the
right,
up against the bobbin winding stopper. Step on the foot controller to begin winding the
bobbin, and then stop to trim the thread tail. Step on the foot controller again to resume
winding the bobbin. When the bobbin is full, push the spindle to the left, clip the thread
and remove the bobbin from the winder.
INSERTING THE BOBBIN
To insert the bobbin, first remove the bobbin cover plate.
Place the bobbin into the bobbin case.
Pull the thread tail to check that the bobbin turns in a counter-clockwise direction. If it
turns in a clockwise direction, remove it from the bobbin case, turn it over and replace it
