S T / V T V E N D O R
•
3 5 6 8 3 5 6 7 3 5 6 6 3 5 6 5
•
5
4 2 2 0 5 5 7 R e v A
FIG 1. : Remove Skid Boards
REFRIGERATION
MODEL
Embraco 1/3 HP
TYPE
Hermetically Sealed
CONTROLS
Electronic
REFRIGERANT
R-134a
CHARGE
16 oz
COIN CHANGER, BILL VALIDATOR, CARD READER
TYPE
MDB Coin Changer level II or III, Bill Validator Level I,
Card Reader Level I or II
VENDOR OPERATION
LOCATION
Suitable for indoor use only. This appliance is not suitable for installation
in an area where a water jet could be used.
SOUND LEVEL
PRODUCES LESS THAN 70 DBA DURING NORMAL OPERATION.
RECOMMENDED
OPERATING
TEMPERATURE
Between 40°F and 100°F (4° and 38° Celsius)
UNPACKING
This vendor was thoroughly inspected before leaving the factory and the
delivering carrier has accepted this vendor as their responsibility. Note
any damage or irregularities at the time of delivery and report them to
the carrier. Request a written inspection report from the claims inspector
to file any claim for damage. File the claim with the carrier (not the
manufacturer) within 15 days after receipt of the vendor.
Carefully remove the outside packing material so as not to damage the
finish or exterior of the vendor. Inspect the vendor for concealed
shipping damage. Report any damage hidden by the shipping material
directly to the delivering carrier on a hidden damage report.
Record the model number and serial number of the vendor for your
records. These numbers can be found on the serial plates on the rear of
the cabinet and/or inside the vendor. Refer to these numbers on all
correspondence and inquiries pertaining to this vendor.
Remove the shipping skids by supporting the vendor from below,
inserting a large screwdriver or prying tool into the grove and splitting it
in two. After removing the pieces, turn the leveling screws in as far as
possible. (See Figure 1).
INSTALLATION
Consult local, state and federal codes and regulations before installing the vendor.
Retrieve the keys to the vendor from the coin return cup.
Open outer door and remove all internal packing material.
Position and level vendor prior to connecting vendor to power. All set up must be completed prior to prevent harm to the
installer or vendor.
