S T / V T V E N D O R
•
3 5 6 8 3 5 6 7 3 5 6 6 3 5 6 5
•
6
4 2 2 0 5 5 7 R E V A
FIG 2. : Disconnect harness plugs
FIG 3. : Remove Control Board
Cover
FIG 5. : Remove Top Hinge
FIG 6. : Remove Leg Mounts
FIG 4. : Remove Top Door Screws
REMOVING THE DOOR
The vendor will fit through most doorways (34"+) by opening the vendor outer door and
carefully walking the vendor door or cabinet thorough first and then moving the remaining
portion of the vendor through. The vendor outer door may be temporarily removed to
permit easier movement through a narrower door openings or hallways. To remove the
outer door:
1.
Disconnect door harnesses:
Loosen the nut and bolt attaching the harness retaining spring to the door
harness and unhook the spring from the harness.
Unplug the door harness and glass heater harness (option) from the power
panel. (See Figure 2).
Remove harness clamps and cable ties retaining door harness to door.
Remove control system cover (see Figure 3) and disconnect door harness
plugs from control board.
2.
Remove the door:
This requires a minimum of two people. Open the door at least 90
degrees. While someone holds the door in place to prevent bending or damage to the
bottom pivot, remove the three (3) 5/32" hex socket/Allen screws fastening the top
hinge assembly to the top of the door (see Figure 4). Once these screws are removed
the door needs to be lifted vertically off the bottom hinge. The bottom hinge pin rests
on top of nylon washers to provide proper door height and smooth operation … retain
these washers for reassembly.
REMOVING THE HINGES AND FRONT LEG MOUNTS
The cabinet depth can be narrowed to approximately 31" with the additional removal
of the door hinges and front leg mounts. These may be temporarily removed to
permit easier movement through a very narrow door openings (32") or narrow/angled
hallways.
1.
Mark the Door Hinge locations:
Mark the location of the top and bottom hinges
with a pencil for proper locating upon reassembly.
2.
Remove the Top Hinge:
Remove the two (2) small locating screws and four (4)
large bolts and nuts holding the Top Hinge Plate to the cabinet (See Figure 5). Save
the mounting hardware for reassembly.
3.
Remove the Front Leg Mounts:
From the underside of the cabinet remove the
four (4) bolts that secure the front leg mounts. NOTE: Be sure to leave the two
inside bolts on each cabinet leg. Pull the leg mounts out forward to remove. (See
Figure 6.)
4.
Move machine in to final location
5.
Reassemble in reverse order
6.
Level vendor and check door handle closure
Disconnect door harness plugs
Remove
screw to
lift cover
Remove these 4 bolts
Leave these 2 bolts
