VELBUS INSTALLATION GUIDE
©2015 Velbus
42
www.velbus.eu
You will notice that the
“
rename
”
button
is available in this screen. First
select the module or channel you wish to rename, then click on the “rename”
button. Name changes will not be saved in the modules until you synchronise
with (write to) your installation again.
The detector tab is a great feature to use if you have an assistant to press
buttons in the installation. If you are alone, you can walk around the house
yourself and operate modules/channels in a certain order. When you return to
Velbuslink, the channels will have appeared in the order you activated them
and you can rename them accordingly.
Recap
In short, to get started with a new Velbus project, follow the next steps:
connect your Velbus installation to your PC (for instance with a USB
cable to a VMBRSUSB configuration module)
start Velbuslink
click on “New project” and follow the wizard
give all modules a unique address between 01 and FE (hex) or 0-255
(dec).
rename the modules and channels. This can be done in several ways:
o
by simply selecting them one by one and renaming them
o
by operating the channels from within Velbuslink and checking
which device is activated, then renaming the according
channel
o
by using the Detection tab and physically operating the
buttons, then renaming the channels as they appear.
Don’t forget
to save your Velbuslink project file from time to time.
If you lo
se your Velbuslink project file, there’s nothing to be worried about. You
can simply start a new project and read the modules (synchronize > read). All
actions, configurations and even channel names will appear in your Velbuslink
project, since they were saved in the modules themselves. Only the module
names will be lost (for all but the most recent modules).
Summary of Contents for VMB4RYLD
Page 1: ...Installation Guide ...
Page 2: ...v 2015 08 04 ...