VELBUS INSTALLATION GUIDE
©2015 Velbus
35
www.velbus.eu
At this point, you cannot know which module is to be found where in your
installation. But this is not necessary either, since Velbuslink comes with an
“automatic detection” function.
Just click on the icon to change the address (it does not matter which module
is selected).
The window that appears shows all connected modules with their current
addresses. To change the addresses, we can use automatic detection.
Note: Only use the “automatic detection” function if no two modules with the
same address (apart from “FF”) are present in your Velbus system.
If this should
be the case, manually change the duplicates into new, unused addresses first.
Make sure “Automatically select detected modules” is
ticked. Also check the
filters to the right and verify that detection is activated for the modules you
wish to detect.
Summary of Contents for VMB4RYLD
Page 1: ...Installation Guide ...
Page 2: ...v 2015 08 04 ...