OAM Tx Setup
tab - configures ATM Ping measurement based on different OAM cell types and VCC (VPI/VCI). The following
OAM cell types are available;
F5EE - OAM F5 cell used to verify end-to-end connectivity from the modem (CPE) to the BRAS (Broadband Remote Access
Server).
F5SG - OAM F5 cell used for segmenting the ATM layer to isolate the location and nature of the fault.
F4EE - OAM F4 cell used for controlling the entire connection.
F4SG - OAM F4 cell used for controlling a single segment of the connection.
Note: Operation, Administration, and Maintenance (OAM)
OAM performs standard loopback (end-to-end or segment) and fault detection and notification (alarm
indication signal [AIS] and remote defect identification [RDI]) for each connection. In the BX100A/V, only
loopback cells are used.
OAM Tx Result
tab - displays the ATM Ping result for the corresponding VCC either as Pass (P) or Fail (F) in the status field.
BX100A/V - ATM OAM RX result
BX100A/V - ATM VCC Scan
BX100A/V e-Manual D07-00-001 Rev E01
Page 30 of 52
