40
6. Installation of details
6.2 ELEVATED WASHING MACHINE/TUMBLE DRYER
4
2
1
3
5
6
7
Air gap
8
9
4
2
1
3
5
6
7
Luftspalt
8
9
INSTALLATION
•
For double elevated machines, install (5) the decorative side measuring 288x603x16 mm
with art. no. 357520 on drawer module (3) art. no. 102460N with dimensions height=288 and
width=600 mm, where the fully extending drawer is removed before installation begins, and then
the other drawer module against the decorative side. Use clamps and screw using the supplied
connection screws, art. no. 39611. Start with point two for a single elevated machine.
•
Supporting legs (1) with art.nr. 39238 must be fitted 50 mm from the front and back edges under
the outer side of the drawer module so that the side rests on the supporting leg. Then fit the two
centre supporting legs under decorative side (5) (omitted for single elevated machine).
•
After this, install (2) the decorative sides measuring 1188x603x16 mm with art. no. 357521 from
the underside of the drawer module and up to each outer side of the drawer modules. Use
clamps where needed and screw using the supplied connection screws, art. no. 39611 from inside
the drawer modules.
•
Fix two angle braces (9) art. no. 39614 to each decorative side in order to fit the upper
counter top, 50 mm from the front and back edges, and fit counter top with dimensions
1268/652x610x30 mm (4). Centre the counter top over the unit so that the overhang is the same
on both sides.
•
Screw the drawer modules into the wall with two screws per cabinet (screws are not included
in the delivery from Vedum) through the nailing batten. Do not forget to seal with silicone (not
included in the delivery from Vedum) in the screw holes where required.
•
Check that the counter top is straight and fit bracket (8), dimensions 530x45x45 mm,
art. no. 39232 (screws not included in the delivery from Vedum for the wall fastening) in the
centre against the wall so that the counter top is supported from underneath (omitted for single
elevated machine).
•
Install the counter top (6) with art. no. 3723, dimensions 1214x600x30 mm or 599x600x30 mm
(for single elevated machine) above the drawer modules with connection screws through the top
of the drawer modules and into the counter top.
•
Fit securing strips (7) with art. no. 39333 in front of the machines’ legs with screws art. no. 39116
TFX4x16 (4 pcs per strip) so that the machines cannot move outwards, 16 mm from the front
edge of the counter top.
•
Install the machines there. Any recesses for water/drainage must be made on site in the bottom
or on the side.
Art. no. 39333 Securing strip for
washing machine/tumble dryer
