S-19-01-1125-UV101 V1.3
9
6.3 Timer selection:
(H) Boost – This mode provides high power to the LEDs, helping them generate a higher power output
up to 1,400 mW/cm2. Since the LEDs function at such high power level, only the 5 second curing cycle
is provided to avoid premature LED failure. You can use multiple boost cycles in succession to obtain
longer Boost curing.
Time selection: 3, 5, 10 seconds
(Ramp) Soft Start - an initial 35~50% energy of high intensity and then switch to high intensity
1,400mW/cm
²
constant.
10 seconds (5 seconds low int 5 seconds high intensity)
6.4 Battery Charging
To charge the battery, place the handpiece in the charging base, with the power supply attached to the
charging base, or attach the power supply directly to the handpiece. When this is done, the POWER
INDICATOR (On/Off button surrounding) will illuminate. (Figure 7)
The light may be used with the power supply attached to the handpiece handle, even if the battery is
low. While in this configuration, the battery will charge while the unit is not being used. While charging,
the BATTERY CHARGING INDICATOR (Mode button surrounding) will illuminate. (Figure 7) When the
battery is fully charged, the white indicator will switch off. When the handle is removed from the
charger, or the power disconnected, none of the battery indicators will illuminate.
Ramp mode
indicator
High Intensity
mode indicator
Timer Display
Figure 6
Figure 7
Charging indicator
Illuminates during
charging, turn off
after fully charged.
Power Indicator
Illuminates when
handpiece is connected
to power supply.
