Range of functions of your
navigation system
■
Range of functions
Some of the functions described in this manual
are only to be used in conjunction with op-
tional accessories. It may also be that use
cannot be made of certain functions in some
countries because the data has not been sur-
veyed. Due to the large range of functions, a
conscious decision was taken not to allow all
the settings to be used in any combination in
the interests of ensuring ease of use and
functionality.
■
Operating restrictions
(country-specific)
If a symbol depicting a crossed-out hand ap-
pears in the bottom status line it means that
only limited operating options are available
whilst driving. Whether or not this function
is activated will depend upon the prevailing
national regulations.
Inserting/changing SD cards
■
Inserting the card
☞
Insert the card into the SD card slot with
the label facing up and the slanted corner
on the right.
☞
Press the card into the slot until it en-
gages.
■
Removing the card
☞
Carefully press the centre of the card.
✔
The SD card is released.
☞
Pull the card straight back to remove it
from the SD card slot.
■
Information on SD memory cards
Only insert SD memory cards in the SD card
slots. Inserting other card types can result in
malfunction or destruction of the unit and
the card.
Only use SD memory cards from well-known
manufacturers. The use of other cards may
result in malfunctions.
Do not use miniSD
™
cards with adapters. The
miniSD
™
card could become detached from
the adapter when removing it from the card
slot. The adapter could then get stuck in the
device.
SD is a registered trademark of the Toshiba
Corporation.
The SD logo is a registered trademark.
Remote controls
Depending on the scope of supply, various
remote controls might be used. Full func-
tionality can only be ensured if the correct
remote control is activated.
■
Activating the correct remote control
☞
Select “Settings –> Remote control” and
activate the desired remote control by
pressing the
OK
button.
☞
If you additionally use a steering wheel
remote control, activate this with a tick.
A
Please do not expose the remote control
with inserted batteries to direct sunlight.
■
Active holder (accessory)
If you only use your remote control in ist
active holder, we recommend that you remove
the batteries from the remote control. The
system can be operated when the remote
control is in its holder.
■
Battery change display
If the system no longer responds when the
buttons are pressed or the battery symbol
(
appears in the status line, the batteries of
the remote control must be changed.
OPERATION
SETUP
INSTALLATION
CONTENTS
7
