VBrick 7000 Series, Getting Started Manual

Page: 29 / 78

Shelf Setup
VBrick H.264 Appliance Getting Started Guide 19
Table 7. Power Supply LEDs
If a power supply fails, the LED will turn red and an alarm will sound. Push the alarm reset
button (the small black bubble button to the left of the left power cord receptacle) to silence
the alarm.
T
To remove/replace the power supply:
1. Turn off power to the power supply with switch at bottom and unplug power cord.
2. Pull unit out with handle while pressing the red release lever.
3. When replacing a power supply, push in firmly to seat firmly in backplane.
Figure 8. Dual Power Supplies
Fan Tray
The shelf has a common fan tray with four fans and a replaceable air filter. There are no
user-serviceable components in the fan tray. If an individual fan fails, you must replace the
entire unit or you will invalidate the shelf warranty. Contact VBrick for a replacement fan tray
as soon as possible. The
Status
LED will turn red if any of the fans has failed. To avoid
damaging the blades, do not run the shelf if more than one fan has failed. When you pull out the fan
tray, you can see the fans slowly spinning down. Any fan not spinning down has likely failed.
Table 8. Fan Tray LEDs
T
To remove/replace the fan tray:
1. Loosen the screws on each side of unit.
Color Description
Green Power supply is good.
Yellow AC power is applied but power supply is off.
Red The power supply has failed.
Color Description
Green Fan tray is good.
Red The fan tray has failed. Replace as soon as possible. Do not run the shelf if more
than one fan has failed or the tray been removed.