CB-800
CB-1000
2.7.8.4 T
ROUBLESHOOTING
Problem
Cause
Solution
The engine will not start
The petrol supply line is closed
Open the petrol supply line
Non-functional choke
Visit a service facility
Other defect
Visit a service facility
The work tool will not rotate
Insufficient belt tension
Adjust the tension pulley
Torn belt
Replace the belt
The belt has come off
Re-mount the belt
Other defect
Visit a service facility
The machine is not moving
Insufficient belt tension
Adjust both the tension pulleys
Torn belt
Replace the belt
The belt has come off
Re-mount the belt
Dropped upper gearbox pulley carrier bolt
Fit a new pulley bolt
Other defect
Visit a service facility
Stop the machine or brush rotation
The tension pulley does not return back to its
position
Lubricate
The inner bowden cable is stiff; bent bowden cable Lubricate or replace the bowden cable
The cable is frozen in the Bowden
Let the machine thaw, lubricate the cables
The control levers do not return back.
The inner bowden cable is stiff; bent bowden cable Lubricate or replace the bowden cable
The cable is frozen in the Bowden
Let the machine thaw, lubricate the cables
Broken return spring
Replace with a new one
Other defect
Visit a service facility
Other fault
Visit a service facility
Table 21: Troubleshooting
2.8 S
TORAGE
•
Prevent unauthorized persons from access to the machine.
•
Protect the machine against climatic conditions but do not use impermeable protection to prevent excessive corrosion it may cause.
We strongly recommend the following steps:
Remove any dirt from the machine
Repair any paint damage
Drain the fuel from the engine fuel tank and carburettor - instructions in the engine operating instructions
Perform the post-season machine lubrication per
Table
Inflate the tyres to pressure value
MAX
2.9 M
ACHINE
WASHING
AND
CLEANING
When washing and cleaning the machine, proceed so as to observe valid provisions and laws regarding protection
of water courses and other water resources against pollution or contamination by chemical agents.
Never wash the engine by a water jet! During starting, the engine electric system could malfunction.
You can wash your machine (except for its engine) with a pressure washer. Always lubricate the locations per
Table
2.10 D
ISPOSAL
OF
P
ACKAGING
AND
THE
M
ACHINE
AT
THE
E
ND
OF
ITS
S
ERVICE
L
IFE
•
When you unpack the machine you are bound to dispose of the packaging material according to national laws and decrees concerning
waste disposal.
•
When disposing of the machine at the end of its service life, we recommend proceeding as follows:
Demount from your machine all the parts that may still be used.
Drain oil from the engine and gearbox into a suitable closing container and hand them in at a collection point
.
Remove any plastic and non-ferrous metal parts.
The remaining machine and its removed demounted parts are to be disposed of according to national laws and decrees
concerning waste disposal.
65
The respective local authority will inform you of the disposal centre location.
38
re
vi
ze
1
2/
20
21
