Van's Aircraft RV-12, Maintenance Manual

Page: 95 / 217

Rev. 4
6-9
5. Remove the rudder pedal-block hardware; bolts (2) and washers (2), from each
of the rudder pedal-blocks (3).
6. Remove rudder pedal assembly.
I
NSTALLATION
1. Installation procedure is reverse of the removal procedure.
SERVICE SCHEDULE PROCEDURES
C
ONTROL SYSTEM ROD END LUBRICATION
Tools #2 Phillips
3/8, 7/16 sockets
Expendable Spray lubricant
Replaceable None
Service Rating Line
Minimum Certification LSA-RM, or A&P
Additional References KAI
1. Remove the seat ramp cover, seat floor cover, baggage cover, and fuel tank
assembly. (3-4)
2. Apply lubricant sparingly to the rod-end bearings on each end of the following
components:
♦
Flap handle pushrod
♦
Control stick pushrod
♦
Flaperon pushrod
♦
Trim / Servo pushrod
3. Allow lubrication to penetrate then wipe away excess.
4. Apply grease to F-1266AD Flap Detent Bracket.
C
ABLE END HARDWARE LUBRICATION
Tools None
Expendable Spray lubricant
Replaceable None
Service Rating Line
Minimum Certification LSA-RM, or A&P
Additional References KAI
1. Remove the tunnel cover, seat ramp cover, upper tailcone fairing, and lower
tailcone fairing. (3-4)
2. Apply lubricant sparingly to the hardware at both ends of the rudder and
stabilator control cables.