Van's Aircraft RV-12, Maintenance Manual

Page: 110 / 217

Rev. 5
8-8
Figure 22: Trim/Servo assembly removal
7. Remove the pitch-trim
servo attach screws (6),
washers (6), nuts (6), and
doublers (2) as shown in
Figure 23 .
8. Unscrew the pitch-trim
servo from the pushrod
assembly. Remove the
jam nut from the pitch-trim
servo shaft.
9. Clip the wire terminals off
of the old servo and
remove the snap bushing.
Slide the snap bushing
onto the wires of the new
servo.
Figure 23: Pitch-trim servo removal
1. Install new terminals on the three colored wires of the servo.