Van's Aircraft RV-12, Maintenance Manual

Page: 100 / 217

Rev. 2
7-4
D
ISCONNECTION
1. Drain the hydraulic fluid. (7-5)
2. Make note of the hose connections.
3. Disconnect brake lines from master cylinder.
I
NSTALLATION
1. Installation procedure is reverse of the removal procedure.
2. Bleed the brake system. (7-5)
SERVICE SCHEDULE PROCEDURES
B
RAKE PEDAL TORQUE TUBE LUBRICATION
Tools 7/16 socket
7/16 combo wrench
Needle nose pliers
Expendable Cotter pins
Wheel bearing grease
Replaceable None
Service Rating Line
Minimum Certification LSA-RM, or A&P
Additional References KAI
● NOTE: S
ERVICE ONE PEDAL AT A TIME
.
1. Actuate the rudder
pedals so that the
brake pedal to be
serviced is offset
from the adjacent
rudder and brake
pedal. The
following steps
relate to Figure 19 .
2. Remove the
master cylinder
lower hardware.
3. Remove the brake
pedal hardware;
bolt, washer, and
nut.
Figure 19: Torque tube lubrication