4
LOCKED FOR PRINTING – SELECT SECT. NEEDED >
85
Fig. 37
16
16
17
18. Install idle jet (18), plug (19) and gasket (20),
Fig. 38
.
Fig. 38
18
19
20
19. Install idle mixture screw (21) and spring (22),
Fig. 39
.
NOTE:
DO NOT tighten screw. DO NOT install the
limiter cap at this time.
Fig. 39
21
22
20. Install bowl gasket (24), float bowl (25), washer
(26) and screw (27) or anti-afterfire solenoid
(23), if equipped,
Fig. 40
.
21. Position bowl drain as shown.
22. Torque screw or solenoid to
45 in. lbs. (5 Nm)
.
Fig. 40
23
24
25
26
27
Mikuni Carburetor
Models 290700, 303700, 350700 (Before
951001xx)
Check Throttle, Choke Shaft and Body For Wear
NOTE:
The measurement in Step 1 is taken with the
carburetor off of the intake manifold.
1. Lay carburetor on flat surface. Use a feeler
gauge (1) to check throttle and choke shaft
clearance as shown in
Fig. 41
.
Fig. 41
Throttle shaft and choke shaft clearance must not
exceed
0.010” (0.25 mm)
.
NOTE:
The inspection in Step 2 is performed after
the carburetor has been disassembled.
2. Inspect throttle shaft and choke shaft for wear
(2),
Fig. 42
.
