12
LOCKED FOR PRINTING – SELECT SECT. NEEDED >
167
Fig. 13
2. Install valve covers with new gaskets and valve
cover seals (6),
Fig. 14
. Torque nuts (7) to
25 in.
lbs. (3 Nm)
.
NOTE:
Models
540000, 610000
–
70 in. lbs. (8 Nm)
3. Repeat for No. 2 cylinder.
4. Adjust valve clearance. See Section 1.
Fig. 14
Install Starter Motor, Breather, Alternator
1. Install back plate (1),
Fig. 15
. Torque screws to
65 in. lbs. (7 Nm).
2. Install alternator (2). Torque screws to
20 in. lbs.
(2 Nm).
CAUTION:
Route alternator wire(s) behind starter
motor. DO NOT pinch wires.
3. Install starter motor (3). Torque screws to
140 in.
lbs. (16 Nm).
4. Install breather,
Models 290000 – 350000
.
Torque screws to
30 in. lbs. (3 Nm)
.
Fig. 15
Install Flywheel
All models except Engines with POWERLINK
t
CAUTION:
Clean flywheel and crankshaft taper.
Remove ALL oil, dirt and grease.
1. Assemble flywheel to crankshaft and align key-
ways.
2. Insert flywheel key into crankshaft.
Torque Flywheel Nut
Models 290000, 303000, 540000, 610000
1. Install starter hub (if equipped), washer and fly-
wheel nut.
2. Place Flywheel Strap Wrench
#19433
(1)
around outer rim of flywheel,
Fig. 16
.
3. Use torque wrench (2) to torque flywheel nut to
125 ft. lbs. (175 Nm)
. Models 290000, 303000
and 150 ft. lbs. (203 Nm). Models 540000 and
610000.
Fig. 16
