Technical description
6 Communication
6.1 Communication ports
VM265.EN011
VAMP 24h support phone +358 (0)20 753 3264
139
6.1.3.
Extension port X4
This is a non-isolated RS-485 port for external I/O devices. The
port is located in the same rear panel D9S connector X4 as the
local port, but pins (7, 8, 5) are used instead of the standard
RS-232 pins (2, 3, 5) used by the local port. See Figure 6.1-1.
Parameters
Parameter Value
Unit Description
Note
Protocol
None
SPA-bus
ProfibusDP
ModbusSla
ModbusTCPs
IEC-103
ExternalIO
DNP3
Protocol selection for the
extension port.
Command line interface
for VAMPSET
SPA-bus (slave)
Profibus DB (slave)
Modbus RTU slave
Modbus TCP slave
IEC-60870-5-103 (slave)
Modbus RTU master for
external I/O-modules
DNP 3.0
Set
Msg#
0 ... 2
32
1
Message counter since the
device has restarted or
since last clearing
Clr
Errors
0 ... 2
16
1
Protocol errors since the
device has restarted or
since last clearing
Clr
Tout
0 ... 2
16
1
Timeout errors since the
device has restarted or
since last clearing
Clr
speed/DPS
Default =
38400/8N1 for
VAMPSET
Display of actual
communication
parameters.
speed = bit/s
D = number of data bits
P = parity: none, even, odd
S = number of stop bits
1)
Set = An editable parameter (password needed)
Clr = Clearing to zero is possible
1) The communication parameters are set in the protocol specific menus. For
the local port command line interface the parameters are set in
configuration menu.
Summary of Contents for 265
Page 2: ...VM265 EN011...
Page 219: ...VM265 EN011...