![background image](http://html1.mh-extra.com/html/valore/l3-1800kn/l3-1800kn_installation-manual_852148049.webp)
49
Installation
Remote Control Pairing
Remote Control Initial Pairing
The receiver and the handset of the remote control
system must be initially paired before the
fi
rst use.
(Note that batteries must already be installed in the
wall mounted battery holder)
1. Insert two 1.5 V AAA
alkaline
batteries in the hand-
set.
2. Locate the Reset button on the front side of the
receiver.
3. With a thin object, press and hold the receiver’s
RESET button until you hear one short and one long
beeps. After the second beep, release the reset but-
ton.
4. Within the subsequent 20 seconds, press and hold
the button on the remote handset for 2-3 sec-
onds.
will be displayed and
fl
ash on the hand-
set during the pairing sequence. The handset will
count up from 1 to 8, and you will hear two short
beeps con
fi
rming the pairing is done.
If you hear one long beep, the pairing sequence has
failed or the wiring is incorrect.
This is a one time pairing only and is not required when
changing the batteries of the handset or battery holder.
The remote control system is now ready to use.
Radio Frequency
918.0 MHz for USA and Canada.
This device complies with Part 15 of the FCC Rules
and with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
Battery
wall holder
connection
Reset
button
Velcro
Appliance’s
front panel
Reset button
RESET
Receiver behind front panel,
left of gas valve