72
Appendix D - HeatShift™
Con
ȴ
guration H3 with LDK8
The LDK8 plenum is typically installed directly above
the H3 unit, connected by the LDK11 (or approved 4”)
liners. It may be o
set from center, or vented to the
rear if desired.
Note: Coaxial vent can be routed vertically through the
cutout in the HeatShift plenum. If the plenum must
be o
set to the rear, the vent must also be o
set to
accommodate.
Ʉ
WARNING
The plenum duct kits are approved for
horizontal discharge ONLY. DO NOT install
plenum in
ȵ
oor or ceiling. DO NOT COVER
OR PLACE objects in front of or on top of
air outlet(s). AVOID locating outlet within
7 feet of the
ȵ
oor level as discharge air
temperatures are hot!
D O N O T D I S C H A R G E T H R O U G H
E X T E R I O R W A L L S !
Dimensions
30” [762 mm]
39” [991 mm]
11
” [
28
0 m
m
]
3” [76 mm]
2” [51 mm]
6” [153 mm]
9”
[2
29
m
m
]
8-
1/
2”
[2
16
m
m
]
1/2” [13 mm]
4” [102 mm] Ø
Front View
Bottom View
Side View
Notch dimensions:
Depth 2-7/8” [74 mm]
Width 6-3/4” [172 mm]
