53
IMPORTANT: The
connection can only
be done one way.
Do not force it or
damage the pins on
the receiver box!
Install Remote Battery and Wall Switch Kit
(required)
The Remote Battery and Wall Switch Kit is provided
with this appliance. It connects to the receiver in the
fi
replace.
The receiver is located under the
fi
rebox, left of the
control valve. It is maintained in position with
Velcro
bands.
1. Pull out the receiver from its location to connect the
battery holder and wall switch.
2. Feed the ‘white connector end’ of the harness as-
sembly through side holes in
fi
replace liner body to
receiver. Ensure su
ffi
cient harness length to allow
for removal of receiver. Note - coil up any extra har-
ness at
fi
replace end.
3. Connect switch to auxillary 5-pin junction and
power connection to jack.
4. Run harness assembly to mounted position of junc-
tion box, securing harness to framing using insu-
lated staples (not included)
5. Feed harness assembly through a restrain on rear
of junction box, feeding through until harness
sheath is pinched by retainer and providing suf-
fi
cent length to make connection to rear of switch
and battery holder.
6. Secure junction box to the mounting surface using
appropriate fasteners (not included)
7. Align molex connection on switch cable of harness
assembly and connect to switch.
Caution
DO NOT PUT BATTERIES IN THE BATTERY HOLDER
until the wires are connected to the burner
control unit as short-circuit could result in the
destruction of the electrical components.
Do not run the switch wire over the top of the
firebox. Route the wire so it does not contact the
firebox.
Installation
Wall Switch
