16.2 To remove the burner unit.
1.
Remove the fascia as in section 16.1.
2.
Remove the ceramic fuel effect pieces.
3.
Detach the spillage plate from the hotbox by
removing the four screws (See figure 40). Place
the spillage plate in a safe place away from the
work area.
4.
Remove the six screws from the side of the
inner reflector (See figure 41).
5.
Carefully lift the inner reflector and pull forward
to remove.
Be careful not to scratch the top surface of the
burner cover.
Place the inner reflector in a safe
place away from the work area.
6.
Remove the two screws to the side of
the burner cover (See figure 42)
7.
Detach the burner cover by lifting
clear of the burner module (See figure
42). Place the burner cover in a safe
place away from the work area.
8.
Isolate the gas supply at the inlet
isolating ‘T’ connector
9.
Support the inlet ‘T’ connector to
avoid straining the pipework and
disconnect the appliance from the inlet ‘T’
connector.
10.
Detach the burner unit from the
hotbox by lifting clear
11.
Replace in the reverse order.
Page 37
©
Baxi Heating U.K. Limited 2008.
INSTALLER GUIDE
Figure 42. Removal of burner module
Figure 41. Removal of inner reflector
Figure 40. Spillage plate removal