5. PRE-INSTALLATION PREPARATION
5.1 Unpacking.
The carton contains the following:-
1off
Fire assembly.
1off
Ceramic fuel effect (In packaging inside firebox).
1off
Closure plate.
1off
Smoke match tube.
1off
Olive & olive nut for gas line connection
1off
Literature pack
Remove all the items carefully to prevent damage. Some items may be contained in
the packaging fitments - Examine the packaging carefully before discarding. Check
that all the items are present and undamaged.
5.2 Fireplace flue pull.
Close all doors and windows in the room in which the appliance is to be installed.
After confirming with a match that smoke is drawn into the flue, light a 13 gram
smoke pellet and check that there is a definite flow through the flue. Verify outside
that the smoke exits from one terminal only and that the termination is suitable.
Observe, where possible, upstairs rooms and loft spaces for signs of escaping smoke
indicating a defective flue. If there is not a definite flow warm the flue for a few
minutes and repeat the smoke pellet test. If there is still no definite flow the flue may
need remedial work –
Do not fit the appliance until there is a definite flow
through the flue.
5.3 Appliance preparation.
5.3.1.
Stand the fire upright.
5.3.2
Remove two transit screws from the upper
back panel (See figure 4).
5.3.3.
Remove the control knob by pulling clear of
the gas tap spindle.
5.3.4.
Remove the control bezel by unscrewing two
screws (See figure 5).
5.3.5.
Detach the fascia by removing the screws at
the sides (See figure 5).
Spring the bottom corners of the fascia outward and
pull the bottom of the fascia forward to clear the
fixing brackets. Lift the fascia upward and forward
to clear the top location (See figure 5).
5.3.6.
The front of the fascia is secured by two screws as shown in figure 6. These
screws have been tightened to avoid damage to the fascia during transit. These
screws must be slackened to enable the customer to remove this section of the
fascia. Slacken the two screws, detach the window surround by sliding it upward and
then swinging the bottom forward. Lift and store carefully.
Page 15
©
Baxi Heating U.K. Limited 2008.
INSTALLER GUIDE
Figure 4. Transit screws.
