VALMETAL H Series, Operator'S Manual And Parts Book

Page: 38 / 86

SERVICE & MAINTENANCE
34
E. Two (2) jack shaft bearings.
F. Front blower bearing.
G. Tub drive chain lubrication (use spray chain
grease) (figure 29).
H. Auger drive chain lubrication (figure 28).
3. Check belt and roller chain tension. Replace
springs or adjust anchor nut as required.
NOTE
Coil spacing on each spring
should be at least 3 mm
(1/8 inch).
E
E
F
H
G
Fig. 27 JACK SHAFT BEARING
Fig. 28 INPUT DRIVE BELT SPRING
Fig. 29 TUB DRIVE CHAIN SPRING
Fig. 30 REAR SPRING TENSIONERS