VALMETAL H Series, Operator'S Manual And Parts Book

Page: 32 / 86

OPERATION
28
4.9 TRANSPORTING
ValMetal Round Bale Grinders are designed to be
easily and conveniently moved from place to place.
When transporting, follow this procedure:
1. Be sure all bystanders are clear of the machine.
2. Be sure that the machine is securely attached
to the towing vehicle with a retainer in the
drawbar pin. Always use a safety chain
between the machine and the towing vehicle.
3. Install the light bar and connect to the towing
vehicle. Clean all lights and reflectors and
make sure no bulbs are burned out before
going on a public road.
4. Be sure the machine can be seen by oncoming
and overtaking traffic.
5. During periods of limited visibility use pilot
vehicles.
6. Do not allow riders.
7. Be sure the SMV emblem is mounted and
clean.
8. Do not exceed 20 mph (30 km/h) when trans-
porting. Table 1 gives the acceptable transport
speed as the ratio of tractor weight to Grinder
weight.
Table 1 Speed vs Weight Ratio
9. Always use hazard flashers on the tractor
when transporting unless prohibited by law.
10. Turn the discharge chute or spout toward the
tub. Insure that the machine is as narrow as
possible before transporting.
11. Watch for overhead obstructions and stay
away from power lines. The machine is not
grounded. Electrocution can occur without
direct contact.
TRANSPORT SAFETY
1. Make sure you are in compliance with all
local regulations regarding transporting
equipment on public roads and highways.
2. Make sure the Slow Moving Vehicle
emblem and all the lights and reflectors
that are required by the local highway and
transport authorities are in place, are clean
and can be seen clearly by all overtaking
and oncoming traffic.
3. Do not allow anyone to ride on the Grinder
during transport.
4. Do not exceed 32 km/h (20 mph) when
transporting the machine. Reduce speed
on rough roads and surfaces.
5. Use a tractor of 60 horsepower or more to
transport machine.
6. Install lighting bar before transporting.
7. Use a drawbar pin with provisions for a
retainer. Install the retainer.
8. Attach safety chain between tractor and
machine before transporting.
Road Speed
Weight of fully equipped or load
implement(s) relative to weight
of towing machine
Up to 32 Km/h
(20 mph)
Up to 16 Km/h
(10 mph)
Do not tow
1 to 1, or less
2 to 1, or less
More than 2 to 1