Vallox Vallox TSK Multi 80 MV, Manual

Page: 46 / 108

46 46
To replace the filters:
1. Disconnect the ventilation unit from the mains electricity supply.
2. Lift the latch to open the door of the Vallox ventilation unit.
3. Lift the door off.
CAUTION
The door is heavy.
4. Remove the old filters (A, B, C) and discard them.
5. Install the new filters (A, B, C).
6. Close the door of the unit. Ensure that the safety switch catch
of the door is touching the safety switch, allowing the unit to be
turned on.
7. Plug the ventilation unit back into the mains.
The filters have now been successfully replaced.
CLEANING THE HEAT RECOVERY CELL
(USER)
Check that the heat recovery cell is clean roughly once a year,
or whenever the filters are being replaced. Clean by washing as
required.
To check and clean the heat recovery cell:
1. Disconnect the ventilation unit from the mains electricity supply.
2. Open the Vallox ventilation unit door by first lifting the latch
fully up and then lowering it back a little way.
3. Lift the door off.
CAUTION
The door is heavy.
4. Remove the filters (A, B, C).
5. Remove the sealing strip (E) above the cell in the direction of
the arrow.
6. Lift and pull the cell (D) out of the unit.
7. If the cell is dirty, clean it by immersing it in warm water, to
which a small amount of a mild detergent has been added.
8. Rinse the cell clean with a water spray. Do not use a high-
pressure cleaner.
9. When all the water has drained from between the layers,
reassemble the ventilation unit in the reverse order.
10. When reassembling Vallox 096 MV, check that the sealing strip
below the cell is pressed against the bottom of the unit.
11. Close the door. Ensure that the safety switch catch of the door
is touching the safety switch.
12. Plug the ventilation unit back into the mains.
The heat recovery cell has now been checked and cleaned.
IMPORTANT
Handle the cell carefully! For
example, do not lift the cell by
the layers. The cell layers are
very thin and easily damaged.
MAINTENANCE
IMPORTANT
If the unit has an enthalpy cell,
it must not be washed. Only
aluminium or plastic cells can
be washed.