Vallox Vallox TSK Multi 80 MV, Manual

Page: 15 / 108

15
© Vallox Oy - All rights reserved
INTRODUCTION
STARTING UP AND SHUTTING DOWN THE UNIT
Unit software
We recommend that the latest software version be always
used. Check and download the latest version at
http://www.vallox.com or at cloud.vallox.com either before or
immediately after startup.
The current software version of the ventilation unit is shown
on the control panel display when the unit is connected to
the mains or factory settings are restored. Alternatively, the
current software version can be checked from the Diagnostics
display of the Maintenance menu.
Download the software into the unit using the USB Micro-B
port of the control panel.
Starting the unit
If you are starting the ventilation unit for the first time or after
a maintenance procedure, first connect it to the mains. This
will start the unit. During start-up, the diagnostics display
appears for a few seconds. Once the download is complete,
a profile display opens showing the latest saved status of the
unit.
If the ventilation unit was turned off from the control panel
(see Turning the unit off), you can start it by pressing any
control panel button.
Turning the unit off
To turn the ventilation unit off:
1. Select
Turn unit off
using the arrow buttons.
2. Select
OK
.
3. Press
OK
to confirm the selection. The ventilation unit
has now been turned off.
IMPORTANT
It is recommended that the ventilation be kept turned on
without disruptions.
NOTE
The first starting of the unit may
take a while, because of the
software version check.