Center Pivot 7000, 8000, 8120 Series 75
MAINTENANCE
Miscellaneous
2 Wheel E-Z Tow Pivot
Mechanical End Gun Ramp Adjustment
The end gun shut off locations are adjusted by cut-
ting and splicing the rubber ramps as illustrated in
Figure 75-1.
The ramps are then placed on the inside of the ring
as illustrated in Figure 75-1.
The ramps represent the locations where the end
gun will turn off.
NOTE
• Make sure of proper contact between ramps
and switch rollers.
Notice that the control box is located 180 degrees
from the direction the pivot extends from the elbow.
See Figure 75-1.
Therefore, the ramps must be placed 180 degrees
opposite the action point. Figure 75-2 illustrates the
ramp placement to shut the end gun off at the high-
way location.
NOTE
• Very small changes in the location of the end
gun shut off ramp can result in MUCH greater
distance changes at the outer end of the ma-
chine.
1
1
2
2
3
4
Figure 75-1 1. End Gun Ramp (placed on inside of ring)
2. Mounting Ring
3. 3/8 in Hex Nut (for spacer)
4. End Gun and Stop In Slot Control Box
1
2
3
3
Figure 75-2 1. End Gun Ramp
2. End Gun and Stop In Slot Control Box
3. End Gun Shutoff Area
Summary of Contents for Center Pivot 7000 Series
