To activate the boost mode, hold down the throttle when riding. The
throttle acts as an On/Off switch and as soon as you release the
throttle the boost mode will stop.
MAINTENANCE
Maintenance mode
When maintenance is needed on your Valeo e-bike system the display
screen shows the wrench icon. The associated maintenance code is
displayed at the bottom of the screen.
The wrench may be blinking in case of a minor issue or if maintenance
is required.
When a critical error occurs the wrench icon will be fixed and
associated with an error code.
When this happens, stop riding your
e-bike immediately and visit your authorized Valeo Cyclee™ dealer.
Charging mode
When the e-bike battery is charged while on the bike, the display
screen only indicates the battery icon showing an approximate state
of charge and the exact value at the bottom of the screen.
WALK ASSIST AND BOOST MODE
Walk assist
The walk assist mode is helping you to push the e-bike when walking
on its side. The walk assist mode is moving the bike forward up to 6
km/h or 3.7 mph.
You can activate the walk assist by holding down the throttle of the
deported remote. When releasing the throttle the walk assist stops
automatically.
Note: In reverse mode, pushing the throttle will move the bike
backwards.
In walk assist or reverse mode the pedals may turn at the same
time. Make sure there is enough space between yourself and the
e-bike.
Boost mode
When riding on the bike, you can use the boost mode to accelerate or
climb a slope for a brief period of time.
18
19