Loading Media
DuoPrint Series
34 Operating
Manual
10.15
6.2 Loading Label Roll with Option PA 8X
Figure 9
1. Open the printer cover.
2. Insert the CV label unwinding device PA 8X from behind in the
provided cut-out in the rear wall and fasten it using 3 Philips head
screws.
1. Turn the red pressure levers (B) anticlockwise to fold back the
printheads (A).
2. Remove the outer label holding device from the optional
unwinding device (G).
3. Place the label roll with inner winding on the unwinding device
(G).
4. Re-install the outer label holding device.
5. Pass the label material over the dancer roll (F) and under the
deflections shafts (E + D) and the printheads (A).
Ensure that the material runs through the photocells (F).
6. Turn the red pressure levers (B) clockwise until they engage to
fold down the printheads (A).
7. In front of the front printhead, the tear-off edge (J) can be seen.
8. Enter the offset value under the menu item
Initialisation/Tear-off Edge
.
9. Align the adjusting ring (H) on the deflection shaft (D) and the
label guidance (C) with the material width.
10. Close the printer cover.
Retrofit option CV label
unwinder PA 8X
Load label material
